Connecting a CAT controller to a Kenwood TKR-720 or TKR-820 Repeater can be accomplished easily by following these steps.

Build a interconnect cable with a DB-25 male connector on one end and a 15 pin Molex connector on the other end. (Note: a pre-built cable can be special ordered from CAT).

Note: Install a 2200 ohm pull-up resistor on the controller board at the COR #1 position. Set dip-switch #1 to the ON position for an active low COR.

Connector is a male Molex catalog #1625-15PRT (.062 inch pin spacing)

Computer Automation Technology, Inc.
4631 N.W. 31st Avenue, Suite 142
Fort Lauderdale, Florida 33309

Send mail to Webmaster with questions or comments about this web site.

Copyright © 2003-2004 www.catauto.com. All rights reserved.