Announcement Announcement Module
Collapse
No announcement yet.
Port 2 link control not working Page Title Module
Move Remove Collapse
X
Conversation Detail Module
Collapse
  • Filter
  • Time
  • Show
Clear All
new posts

  • Port 2 link control not working

    I can not get our CAT250 to respond to control op commands or user macros on the link radio, connected to port 2 at connector J1. We need to use port 2 for control op commands and user macros only. We are not planning to use it to link between the two ports. If I am reading the manual correctly, all we need enabled are Zone 3, #1 & #2.

    Control op commands and user macros work on the repeater side, port #1.
    We can link port #1 & port #2 but only from the repeater side, port #1.

    Receive audio level has been verified and properly set at TP6

    Zone 2 #1 is enabled (don't think we need this but it's enabled for testing)
    Zone 2 #2 is not enabled
    Zone 2 #3 is not enabled (not connected but could be)

    Zone 3 #1 is enabled (port #2 control op enable)
    Zone 3 #2 is enabled (port #2 user macro enable)

    Thanks for your assistance.
Working...
X